Aeroponic Vegetation Unit Assembly Instructions vers 1.1

Step 1 – Cutting the ½” PVC Pipe

1) Cut seven 7” lengths.

2) Cut 1 10” length.

3) Cut two 1½” lengths.

4) Cut one 17¼” length.

Step 2 – Preassemble Your Sprayer Frame

1) Start with the top “H”. It’s made from the 3 – Tees & two 1½” pipes.

2) Add the elbows to the tips of the “H”.

3) Add the 7” legs and end caps.

4) Add the 10” drain pipe to the “H”. Do not attach the ball valve yet.

5) Attach the 17¼” pump connecting pipe to bottom of the “H”.

Step 3 – Drilling the Sprayer Holes

1) Measure and mark the sprayer holes (according to the plans).

2) Use the 11/64” drill bit for the ten holes.

Step 4 – Drilling the Lids & Containers

1) Measure out 18 holes as shown in the plans.

2) Use the 2” hole saw to cut the holes.

3) Mark the exact center inside the plant container. Cut a 2” drain hole.

4) Cut a 2” drain hole in the exact center of the reservoir lid.

5) Cut a 2” access hole in the corner of the reservoir lid so you can see and maintain water level.

6) Cut a 13/16” hole in the side of the plant container for the drain valve (according to the plans).

7) Use the Exacto Knife to clean up the holes.

Step 5 – Final Assembly

1) Place the sprayer unit into the container and check to make sure everything fits well.

2) Take apart the sprayer unit.

3) Start the final assembly on the sprayer unit. Start applying glue to each piece. Be careful because

the glue dries fast! Do only one part at a time until the unit is completely assembled.

4) Screw in the sprayers. You may need to use a pair of pliers to get them in.

5) Put the pump in the reservoir and attach the down pipe.

6) Put the reservoir lid on and place the plant unit on top.

7) Connect the sprayer unit to the down pipe (pump).

Step 6 – Mixing the Nutrient Formula

Botanicare Nutrients:

1) 126ML Cal-Mag Plus

2) 180ML Liquid Karma

3) 540ML Pure Bend Pro Vegetative Formula

Mix all the nutrients together in a gallon jug and top off with water. Shake well!

Step 7 – Setup and Conclusion

1) Add 15 Gal. of water. (approx.) to the reservoir

2) Add nutrient mix until the meter reaches 2000 PPM

3) Adjust the PH to 5.8

4) Put the lid on the plant unit.

5) Fill the veg unit with your favorite strains from the clone unit.

6) Set your cycle timer to one minute on and five minutes off.

7) Enjoy your new Veg unit!!!! You should see amazing growth rates.

8) Don’t forget to pass the love on…